Stemco HandBAT RF Bedienungsanleitung

5/29/2012 Page 1 User Reference Guide Active Handheld Reader Turning a unit on When a HandBAT is first picked up the display will normally be

5/29/2012 Page 10  The first line describes the sensor that was read, the read date and time utilizing military time.  The second line ref

5/29/2012 Page 11 To begin the download make sure you are in range of a wireless download pod connected to a PC then press Enter. The followi

5/29/2012 Page 12 Configure – Version When Version is selected the following screen will be shown. This screen will normally only be referen

5/29/2012 Page 13  The Power Down Time sets the amount of time in minutes that a HandBAT screen will remain on when it is left inactive.  T

5/29/2012 Page 14 If customer service should request that you to go into this screen for diagnostic purposes you will be given a password tha

5/29/2012 Page 15 3.) The device should be considered a spread spectrum transmitter. 4.) Typical exposure times are less than 5 seconds during an

5/29/2012 Page 16 CERTIFICATIONS This unit complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) t

5/29/2012 Page 17 Este equipamento opera em caráter secundário, isto é, não tem direito a proteção contra interferência prejudicial, mesmo de e

5/29/2012 Page 2 This is the primary screen option used to read your BAT RF tags installed on your vehicles. To activate this option press the

5/29/2012 Page 3 you cannot read the desired sensor, then increase the range just a bit. Be careful not to increase range too muc

5/29/2012 Page 4 If you press the up ( ↑ ) arrow key, and the HandBAT does not succeed in resetting the trip, error messages will be given with

5/29/2012 Page 5 If you have an AirBAT sensor, use the up/down keys to highlight Active AirBAT from the Select Device screen.  Point the H

5/29/2012 Page 6 If you want to change the limits  Use the arrow keys to navigate to the setting you want to change  Press the Enter Key

5/29/2012 Page 7  Move the hand held reader closer to the appropriate sensor.  Press the Enter Key again and the reader will try and write o

5/29/2012 Page 8 This screen displays how long the current low tire event has lasted.  A tire which has been low for less than 1 hour will

5/29/2012 Page 9  Using the up ( ↑ ) or down ( ↓ ) arrow keys, highlight the Previous Reads option in the main menu.  Depress the Enter Key. T